![]() This tool is not the best tool for the job, however, it is often the easiest. ![]() Get all of this without modifying your geometry or tediously offsetting and deleting scores of lines and curves - let DXF for Laser do the hard work for you! This add-in also supports the creation of multi-layered DXF files, splitting your perimeter and cutouts into their own layers. Then there is the middle ground where parts can be easily dry-fit and disassembled multiple times prior to gluing. By using an aggressive value (say 0.20 mm - or a value larger than your calculated/measured actual kerf) you can make parts that need to be gently pounded together for no-glue assembly. By using this add-in with a small (or even negative) value for your kerf you can make loose fitting parts for a child's puzzle perhaps. ![]() By adjusting your geometry for the width of the laser cut you have full control over how tightly your parts fit together. ![]() Precisely dimensioned laser cut parts are wonderful to work with. Then if you still have problems e-mail me ( and I will provide a workaround. ATTENTION MAC USERS: If you experience issues with the installer please see this article first.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |